Clean-Co Systems Industrial
Service Company is committed to providing the highest quality of work with the
highest degree of safety for our valued customers, employees, and the communities
they support. Our objective of excellence will be realized through rigorous training,
thorough planning and flawless execution. Clean-Co Systems is one of the leading
industrial and specialty cleaning companies in Houston, Texas. We have some of
the largest ultra high pressure water blasting machines in the United States and
a patented process that is definitely a step above the rest. Clean-Co Systems
offers quality performance with an excellent safety record of five years without
a recordable. We also offer 24-hour on call Nationwide service.
A
twenty-percent reduction in cost could be realized by using the Multi-Phased Hydroblaster,
developed by Clean-Co Systems, Inc., if standard hydroblasting was used in prior
projects. Standard Hydroblasting is not always the answer. Planning and scheduling
a shutdown or turnaround is not a small task. Every detail has to be considered
and calculated in order to complete a project within the estimated budget. In
most cases, using actual time and labor costs of previous projects are influential
in establishing the new budget expectations. The Multi-Phased Hydroblaster, developed
by Clean-Co Systems Inc., combines their patented injection cleaning system and
NA-184, a stable hydrolyzed ionic water hardener. This system creates a soft abrasive
in the water, (water hardener) that evaporates, just like water, leaving no residue.
The surface is ready to paint or be put back into service.
The
feed rate of NA-184 water is 100 parts per million (PPM). It is non-toxic and
environmentally safe. It is also undetectable during the cleaning process or upon
completion. The hydrolyzed ionic water causes debris and waste deposits to literally
stick to the droplets and rinse off in one application. A 50% larger nozzle is
utilized, removing more material much faster. A 20 percent reduction in time to
complete a project can add up to 20 % savings overall. When high pressure is needed
to cut through high or low density polymers, rubber, coke, or scaling, Clean-Co
Systems Inc. can “pump up the volume” with 400 horsepower and twelve gallons per
minute of flow. (G.P.M. = depth of cut) Compared to four gallons per minute from
conventional systems, Clean-Co Systems Inc. can reduce time and cost on even the
toughest jobs.
A recent demonstration of the cutting power of the patented
Multi-Phase Hydroblaster was performed at the headquarters of Clean-Co Systems
Inc. Industrial Service Company in Houston, Texas. The hydroblast technician cut
a three-foot diameter ball of high density polymer in half. Starting on one side
and working through to the other, the process took a little over six minutes to
complete. It was very impressive! The next demonstration was the Multi-Phase’s
ability to prepare surfaces for painting and resurfacing. Using an old heat exchanger
with an industrial coating, the hydroblast technician cleaned a twelve inch square
area down to bare metal in mere seconds. The Multi-Phase Hydroblaster will even
cut concrete.
The
feed rate of NA-184 water is 100 parts per million (PPM). It is non-toxic and
environmentally safe. It is also undetectable during the cleaning process or upon
completion. The hydrolyzed ionic water causes debris and waste deposits to literally
stick to the droplets and rinse off in one application. A 50% larger nozzle is
utilized, removing more material much faster. A 20 percent reduction in time to
complete a project can add up to 20 % savings overall. When high pressure is needed
to cut through high or low density polymers, rubber, coke, or scaling, Clean-Co
Systems Inc. can “pump up the volume” with 400 horsepower and twelve gallons per
minute of flow. (G.P.M. = depth of cut) Compared to four gallons per minute from
conventional systems, Clean-Co Systems Inc. can reduce time and cost on even the
toughest jobs. 
