Clean Co Systems patented Multi-Phased Hydro Blaster is an efficient way to deliver
the cutting power of a "Plazma Cutter" but with the safety of water. These methods
of heat free cutting power can be used in sensitive
areas of a facility were flammable liquids and gases are in close proximity. Utilizing
40,000 psi and a special tip that combines a garnet abrasive, the system can handle
cutting through high-density polymer, metal and concrete. The Multi-Phased Hydro
Blaster has replaced the use of "chainsaws" in some Polymer Plants to cut out
and remove hardened plastic from reactors. When entry into tanks and vessels that
have had hydrocarbons and other flammables stored in them is needed, the precision
metal cutting attachment turns the Multi-Phased Hydro Blaster into a safe and
effective alternative to conventional flame cutting. Reducing down time and eliminating
expensive procedures required for the use of flame cutting.
sensitive
areas of a facility were flammable liquids and gases are in close proximity. Utilizing
40,000 psi and a special tip that combines a garnet abrasive, the system can handle
cutting through high-density polymer, metal and concrete. The Multi-Phased Hydro
Blaster has replaced the use of "chainsaws" in some Polymer Plants to cut out
and remove hardened plastic from reactors. When entry into tanks and vessels that
have had hydrocarbons and other flammables stored in them is needed, the precision
metal cutting attachment turns the Multi-Phased Hydro Blaster into a safe and
effective alternative to conventional flame cutting. Reducing down time and eliminating
expensive procedures required for the use of flame cutting. 
